Step 5 Connecting The Transmitted, Receiver and Video Telemetry System

TL;DR

Connect transmitter, receiver, and telemetry system to drone step by step, ensuring proper placement and power connections.

Transcript

good day everyone our next step is to connect the transmitter receiver and the video telemetry system to our drone let's look at it step by step on how to do so we now need to mount and power our receiver typically this run on five volts and are connected to the firewood positive and ground parts of your pdb then will have a signal wire that we wil... Read More

Key Insights

• 📡 Proper placement of receiver antennas and avoiding interference is crucial for a stable signal.
• 🎮 Different transmitters require specific binding methods with the receiver for control.
• 🚵 Mounting the camera and VTX securely on the drone is essential for aerial photography.
• 🎮 Connecting the video signal correctly ensures a clear video feed.
• ✊ Powering components from the PDB with correct voltage inputs is necessary for proper functionality.
• 🚠 Using quality adhesive, cable ties, or tape can secure components effectively on the drone.
• 🫡 Checking component specs and matching voltage inputs is crucial for a successful setup.

Questions & Answers

Q: How should the receiver be mounted on the drone?

The receiver should be mounted away from high-current wires, using quality adhesive. Antennas should be in a V shape, 90 degrees apart, and away from carbon to prevent signal loss.

Q: How do you bind the receiver to the transmitter?

Different transmitters have different binding methods, usually involving holding down a bind button and putting the transmitter in bind mode. Check the transmitter manual for specific instructions.

Q: Where is the best place to mount the camera and VTX on the drone?

Cameras typically have designated mounting spaces, while VTX may require creative solutions like using cable ties or tape. Power them from the PDB with correct voltage inputs to the flight controller.

Q: How should the video signal be connected between the camera and VTX?

Connect the yellow video signal wire from the camera directly to the VTX, ensuring a proper video feed. Match the voltage inputs and splice the wires if necessary.

Summary & Key Takeaways

• Mount and power your receiver on the drone, ensuring proper placement of antennas and avoiding interference.

• Connect the transmitter for remote control, bind it to the receiver, and set up channels for control.

• Mount the camera and VTX on the drone, ensuring proper power connections and securing them in place.